• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Recent content by moresnow=happy

  1. moresnow=happy

    copper/brass washer.

    duh!! temp sensor sorry guys answer my own question got scared and didn't wana keep going then pull it apart
  2. moresnow=happy

    copper/brass washer.

    hey guys just installed new set of pistons in my 2015 pro x 800,, I have a single copper/brass washer its probly important and I can't remember wear it goes any clues? would have come from top half of motor somewears
  3. moresnow=happy

    possible clutch swaps

    just in case anyone ever reads this and wonders the same question. the 550 will definitely not fit. it's still the fuji motor. they had a diffrent tapered fit to the crank. however I successfully installed a clutch from a 2012 600. i am now using the artic cat 048 belt wich is compatible with...
  4. moresnow=happy

    possible clutch swaps

    hey guys been a while!! I have a 2015 switchback pro x 800. my clutch bushing was sticking so I tore the primary apart to find the movable sheeve is cracked 3/4 the way through, thank god it didnt explode. before I buy a new one my question is will a primary off a 2009 550 fit?. obviously...
  5. moresnow=happy

    track stretching

    yes landed on the tail from about 6ft in the air,,, must have been the the one I remember thinking it was a hard landing. yes I owned a 2011 assualt a few yrs ago
  6. moresnow=happy

    track stretching

    hey guys so I compared mine side by side the a friends sled or I would have never noticed my rails are bent up in the back end causing a shorter loop for the track. I'm positive that's why 350$ a rail seems ridiculously priced anyone know aftermarket ones?
  7. moresnow=happy

    Headlights Blinking

    I dont know how its connected but my 15 pro x did it (headlight was a strobe light) when my handle bar warmers were on high, so I took the grip off to find an obvious short, replaced it and no more flicker
  8. moresnow=happy

    track stretching

    stock track 1 3/4" backcountry 4200 miles on it
  9. moresnow=happy

    track stretching

    no studs
  10. moresnow=happy

    track stretching

    hey guys my 2015 pro x switchback 137 track is adjusted right to the max. I thought of takeing the spacer behind jam but out but the axle is at the end in the rail. it's at perfect tension now but seems like it needs adjustments with every 500 miles I put on I'm at 4200 now my question is if i...
  11. moresnow=happy

    2015 800 ho Pro X Clutching Upgrade

    thanks guys. only asking because I already have a 50/44. I am 190 pounds I have stock gears and track for the x I have my sled set to jump and wheelie I cross country ride and boondock way more then trail ride. bit more power and speed always helps! I'll have to check what my springs are and...
  12. moresnow=happy

    2015 800 ho Pro X Clutching Upgrade

    on the subject of the helix angles for the pro x model do u guys think that it will pull a 50-44 with a jaws pipe's added hp?
  13. moresnow=happy

    heated visor not working

    There are two fuses hidden in the sock in front of the primary. Neither were blown. rather then looking and traceing i cheated and ran a new line right from the batteri.
  14. moresnow=happy

    heated visor not working

    Yes there is 100% a fuse there. And it is a 2amp. I was unawaer that there were two. Ill have to go back in as the one i found wasnt blown. It is very tight in there major pain in the rear But yes my tailight does work.
  15. moresnow=happy

    heated visor not working

    Hey guys just woundering if there is a fuse in the axys for the heated visor cord? And wear its located?... my sled is a 15 switchback pro x... i hate chaseing wires just woundering if there is an easy answer on what and wear to look thanks guys.


Back
Top Bottom