2016 Pro-s 800 w/1900 miles. So I got a new block because my ring gear flew off and raised hell with the case. Just wondering if I should see about putting the 18hr break-in mode back on? Is there a way I can prime the oil pump in my garage w/o diggy wrench? Just wondering what your opinions are on this. Thanks!!
New engine. Can the break-in mode be reprogrammed?
- Thread starter Poopoo4me
- Start date
Brock
Well-Known Member
This is what I would do, others may not agree
I would put in 100:1 fuel/oil ratio in first tank and run it hard in and out of throttle in ethanol mode
I wouldn't set break in mode again
Oil pump manual prime requires a power up harness # ps-47296-b and battery
I would put in 100:1 fuel/oil ratio in first tank and run it hard in and out of throttle in ethanol mode
I wouldn't set break in mode again
Oil pump manual prime requires a power up harness # ps-47296-b and battery
- Messages
- 40
- Age
- 47
- Location
- Stillwater, MN
- Country
- USA
- Years Snowmobiling
- 39
- Snowmobile
- All Makes but only the high power models
We can flash whatever length break in you like if you have one of our Bullydogs.
Sent from my SM-G925V using Tapatalk
Sent from my SM-G925V using Tapatalk
flasch192
Active Member
- Messages
- 151
- Location
- Fond Du Lac, WI
- Country
- USA
- Years Snowmobiling
- 22
- Snowmobile
- 2022 850 RMK SLASH Boost
2022 850 XCR 136
dealer can and should have reset break in ........