Recent content by Kerrdog569

I have a pcv with timing for sale that has the dtr map on it,$375

84-8500

I'm gonna do a compression test to compare the two at some point,stock head last time I rode was running between 110-120 without the t-stat, ssi head was 104-107 in similar conditions, 1 is 1% on your pcv, I've talked with a few guys that have the pipe mod and are running in 91 non eth mod and...

Correct I'm using the stock muffler,I even put the stock head back on and took the PCV out,I'm picking my sled up tomorrow,they did a update reflash on the ecu and reset the Tpms baseline to the correct specs,I'll try it again to see if this helps,if all is well I can put everything back on and...

They didn't test the ssi muffler,I had one and I recommend sticking with stock,it's a nice unit but has bad drone @4800-5800rpms,just being honest with ya

Load motor

Mine does the same thing,took it to the dealer Monday, having low idle and stalling going into reverse,no way that sensor can pick up det in 1-2 seconds of wot,I think its a high tps volt causing it cause I put a stock pipe on mine and it still did it

I got a model 030 for the cfi 800,it's the same model according to dyno jet,I don't have the installation sheet for the axys,either way I'm not installing it,so I have one for sale if anyone's interested for 375$ plus shipping

No wasn't aware it was necessary

Did you pull your plugs and check for spark?I had spark but mine wouldn't start til I held the throttle wide open, starts now but seems to idle a little funny,and I need to crack the throttle a tiny bit sometimes when its warm,I pulled the pcv off and the ssi head to see if it goes away,never...

Not for me,I would get det mode no matter which mode I ran in,the ssi head must have more compression or the pipe mod might push more sound wave back in the cylinders causing more compression, either way its off for now til I talk to Erich and see what's going on,originally he told me I could...

I took the head off today and put the stock one back on,going on a trip and don't want to have mess with it and worry about detonation mode kicking in,I might try again or just sell the head and pcv

OK thanks

15 and in eth mode

Hey got a question for you guys,I have the ssi pipe mod and ssi billet head kit,I get det mode once in a while,I'm running 93 10% eth fuel,PCV controller with DTR tune,what's your thoughts,I did some wot pulls about a 1/4 mile long and no issue,it seem like short 2 second wot and chop the...