• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Recent content by LIVINtheLIFE

  1. L

    New member....’17 SBA Setup?

    I’ll gear down if I go to a 1.5 IceRipper track in the future for sure when the 1.35 is done. Little update tho for anybody cruising on the forums, my original setup I noticed was in the 87/Ethanol fuel map on the sled. I took it out today after I got the sea foam and some good fuel in the...
  2. L

    New member....’17 SBA Setup?

    Got it all installed last night along with a freshly broken in Gates belt. Venom primary 120/310 and a Venom secondary 140/220. Delrin washer on each side of the primary and 3 in the secondary(under cup, in cup and in retainer). QAP3’s installed with the total weight 66g +1.9 insert at tip...
  3. L

    Dura Flex Scratchers

    Definitely go with the 2018 and newer SKS snowflap if your going to change your flap, it’s worked wonders for my ‘17 Assault and everyone else that’s switched that I talked to. As for your scratchers look into Between the Lines Design company, they specifically sell duraflex scratchers and make...
  4. L

    New member....’17 SBA Setup?

    I agree, it’s rare but depending on ice condition slush can happen. I probably only tow a sleigh 5-10% of the time. And I’ve never had an issue with the stock gearing(23/40, 1.74). I built a box last year that’s been able to haul all my ice fishing gear on the tunnel for a more “lightweight” setup.
  5. L

    New member....’17 SBA Setup?

    I found a dealer in Canada for all this stuff, picked up some delrin washers for both clutches, Venom 120-310 primary and 140-220 secondary. Along with a set of QAP3’s. Stock helix as of now, stock gearing etc. I’m hoping it’s not too much in regards to using the sled for fishing, towing a...
  6. L

    Are 2018 Assault's ski width adjustable?

    If you heat it up be very careful you’ll ruin your powder coat, heat guns only. Aluminum displaces heat very rapidly it is difficult to concentrate the heat. They probably have a slight interference fit, I’d try pressing it out with something like a ball joint press or bessy clamp and pipe. I...
  7. L

    New member....’17 SBA Setup?

    Hey everyone, first off I’m a new member, just spent the last 2 hours researching the site. I have a bone stock ‘17 SBA 800 w/1.352 track that I bought new with around 2800mi on it now. I decided this year to do some mods to it for myself rather then trading up. Cruising the site I’m seeing tons...


Back
Top Bottom