• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Recent content by Loren Ward

  1. Loren Ward

    Thermostat Defect need help

    Just remove it and put an oring the same size as rubber seal off thermostat
  2. Loren Ward

    Track spin @ Idle

    Did you have drive clutch shimmed for the gates belt. Belt is much wider than polaris belt.
  3. Loren Ward

    Dents in bikeman pipe...can i run it?

    That is the way they are built to keep clearance at certain spots.
  4. Loren Ward

    2015 Pro X

    Try more weight maybe 68 grams
  5. Loren Ward

    Track pitch 2017 SBA 144

    2.52
  6. Loren Ward

    Dalton QAP's setup question

    Anyone have a starting point with dalton wieghts for 15 axys 800 pro s shorty with stage 2 BMP kit. 1:74 gearing and no studs
  7. Loren Ward

    Shock measurements

    17.3 extended 11.45 collapsed 5.85 stroke. Not sure on springs
  8. Loren Ward

    800 axys pistons

    Polaris has changed piston part numbers every year. Can anyone tell me if newest piston will work in 2015 800 pro s.
  9. Loren Ward

    BMP Clutch Kit

    Anyone have a problem with sled not going in reverse with BMP clutch kit installed. Sounds like secondary is opening completely up when hit the throttle and will not move.
  10. Loren Ward

    2016 Pro S track replacment

    Go with the Cobra awesome track.
  11. Loren Ward

    DYNOTYME II !!!!!

    Talked to Jim and he said to add timing. I just need a place to start. Which way is to add timing. Positive or negative
  12. Loren Ward

    DYNOTYME II !!!!!

    I am installing Bikeman pipe on 2017 800 and need to add 2 degrees timing on pcv do I go 2 plus or 2 negative.
  13. Loren Ward

    Un tucked my ssi pro mag weights

    Anyone finding weight bushings not lasting long. I have 300 miles on them and they are worn out.
  14. Loren Ward

    600 CFI2 not revving over 7900

    Check your exhaust valves ,bellows, and springs. Disconnect e/v solenoid hoses and plug nipples run on stand.
  15. Loren Ward

    TEAM TIED TEST

    Should delrin washers be used in tied clutch also.
See more


Back
Top Bottom