Search results

Awesome proS, thx! I wasn't quite sure what would need to be updated if I threw either of the two pipe selections on my 2016. Seems both did extremely well on Tuesday. Can't go wrong with either.

Would heavier weights be needed if the BMP pipe or SSI pipe mod w/PCV hot tune was ran? I currently have 10-70's installed.

Of the 167 HP, how much of that number is associated with the addition of the PCV mapped to the pipe mod?

I'm looking forward to the details Brock. When you guys tested the 2016, did Polaris polish the powerband via the ECU versus the 2015's (from a base or stock perspective)? I have read that the 2016's are leaner by 3% across most of the powerband, but not sure how that equates to efficiency in...

Brock, when I go to lay the alignment tool in the primary and get it ready to measure the gap between the tool and the front of the secondary, do I want to hold it up against the primary inside (crank side) or primary outside (panel side) sheave? I noticed there's some play in between the...

Awesome....thanks Brock. Even though I won't be running an aftermarket exhaust, I'm curious and also anxious to see the results here. It's tests like these where a handful of years ago was not available to the consumer. Outstanding for the members putting this together....

Hey Brock, by the time it's all said and done, will Jim have a PC map for the 2016 800's running a stock exhaust system? Found out this week that his current PC map based on the 2015 800's will not be compatible for anyone who has a 2016.

I'm running the Gates C belt, but I had the primary shimmed and balanced accordingly to this belt. If I didn't have intentions on shimming and balancing the primary, I would simply run the OEM belt. Not sure how much my primary was off, but I was told it needed adjustment for the Gates belt on...

dave....did you remove the exhaust can to do the gear change?

Polaris VES Synthetic....not Legend, not Klotz, not Redline, not Amsoil, just run the OEM oil on these next generation motors.

As bad azz as these new AXYS machines look, it kills me once you see the unfinished rear crank. I dig the red man!

Gates belt is roughly 37mm wide or 1 7/16". Not sure what the width is on the Poo OEM belt. Won't know until tomorrow.