Search results

Plugs are brand new. First thing I tried but no luck.

I have a 08 700 switchback that bogs sometimes when it pulls through mid range. It may pull 6300 rpms and if I pump the throttle a few times it comes through it. I have two identical sleds with the exact same problem. Exhaust valves are all clean and primary is good. Checked rollers,weights and...

I have a 08 700 switchback that wants to bog sometimes. When i cross a crossing and get on it, the rpm may only stay around 6300. After i burp the throttle it will come out of it and run fine. I have went though the exhaust valves and tore the drive clutch apart and all weights and rollers are...

I know in 16 Polaris went with an electric oil pump and got away from the drive on the crankshaft which I feel is a good thing. My son bought a 17 this year and has been a good sled. Just found out his exhaust valve cable (electric operated valves) has broke. Getting it covered under warranty.

I have s sled with two injectors. The sleds with four injectors have an extra wiring harness that goes bad I guess so that will eliminate. Had no electrical issues. I already bought a re nik cylinder. Just waiting on pistons. I put in a new fuel filter and hauling the sled in Monday to have the...

I have the same on mine but it was on the mag side. I have a 2013 600 indy. I was told it's probably the engine wiring harness. It will work and test good but will fail at times putting it in a lean mode and not letting the injector spit fuel.

I had a piston go out on my 2013 600 Indy over the weekend. Has only about 2500 miles on it. Also took out the cylinder also. It is the one on the Mag side. I've been told to replace the engine wiring harness along with new piston & cylinder. I'm just looking for some in put so it don't happen...

What would be wrong with just adding more oil to the gas when you fill?

Hello, new to this sight and looking for some advice. I have a 2017 800 Axys Assault 144" The front end is at 42 ". I am looking for some advice to make it more narrow to 38" or even 36". I was told maybe the front end from axys RMK may work for the a arms and tie rods. Just wondering if anyone...