Recent content by Jimisawesome

Hey Do do any of you know where to put the engine isolator limiter? I'm not sure where it mounts. All of the diagrams just show it and that's it

Thanks for the info that's what I was figuring. I just set the crank in the case yesterday.. you suggested a puller for the flywheel and clutch. Do you need pullers to reinstall?

My machine is carbureted so those might have been thrown in just for the heck of it? The two by themselves at the top look like my crank seals but considerably smaller. And I feel like a complete dummy to ask but when you say inner compression o rings and water jacket o rings where exactly...

Gasket2 by Jimisawesome posted Nov 12, 2018 at 2:33 PMGaskets by Jimisawesome posted Nov 12, 2018 at 2:32 PM Hey all I'm looking for some help identifying these gaskets. 2007 Polaris rmk 600 HO IQ 155 I know the big rings are for the jugs but I'm not sure as to the smaller ones and green ones...

Thanks Lid1 for all the advise. I really appreciate it. Still a long way to go but can't wait to get out on the snow!

Thanks for the info. I'm getting my crankshaft trued. Once I get it back what would I need to do as far as lubrication. Do I pack all the bearings with grease, etc?

Hey Lid1 thanks for the reply. The head and cylinders look fine. The case itself looks fine. There is a little scoring where the rod was rubbing but not anything noticeable beyond that. I haven't inspected too closely yet. In the process of cleaning each component and such. Is the flywheel and...

Hey everyone! My family has moved to Montana and just picked up a sled! I have never riden a snowmobile before but have riden quads and motorcycles my whole life. (Never lived close enough snow trails or anything like that). I just picked up an RMK 600 HO 155. I've been told it's not really a...