Search results

duh!! temp sensor sorry guys answer my own question got scared and didn't wana keep going then pull it apart

hey guys just installed new set of pistons in my 2015 pro x 800,, I have a single copper/brass washer its probly important and I can't remember wear it goes any clues? would have come from top half of motor somewears

just in case anyone ever reads this and wonders the same question. the 550 will definitely not fit. it's still the fuji motor. they had a diffrent tapered fit to the crank. however I successfully installed a clutch from a 2012 600. i am now using the artic cat 048 belt wich is compatible with...

hey guys been a while!! I have a 2015 switchback pro x 800. my clutch bushing was sticking so I tore the primary apart to find the movable sheeve is cracked 3/4 the way through, thank god it didnt explode. before I buy a new one my question is will a primary off a 2009 550 fit?. obviously...

yes landed on the tail from about 6ft in the air,,, must have been the the one I remember thinking it was a hard landing. yes I owned a 2011 assualt a few yrs ago

hey guys so I compared mine side by side the a friends sled or I would have never noticed my rails are bent up in the back end causing a shorter loop for the track. I'm positive that's why 350$ a rail seems ridiculously priced anyone know aftermarket ones?

I dont know how its connected but my 15 pro x did it (headlight was a strobe light) when my handle bar warmers were on high, so I took the grip off to find an obvious short, replaced it and no more flicker

stock track 1 3/4" backcountry 4200 miles on it

no studs

hey guys my 2015 pro x switchback 137 track is adjusted right to the max. I thought of takeing the spacer behind jam but out but the axle is at the end in the rail. it's at perfect tension now but seems like it needs adjustments with every 500 miles I put on I'm at 4200 now my question is if i...

thanks guys. only asking because I already have a 50/44. I am 190 pounds I have stock gears and track for the x I have my sled set to jump and wheelie I cross country ride and boondock way more then trail ride. bit more power and speed always helps! I'll have to check what my springs are and...

on the subject of the helix angles for the pro x model do u guys think that it will pull a 50-44 with a jaws pipe's added hp?

There are two fuses hidden in the sock in front of the primary. Neither were blown. rather then looking and traceing i cheated and ran a new line right from the batteri.

Yes there is 100% a fuse there. And it is a 2amp. I was unawaer that there were two. Ill have to go back in as the one i found wasnt blown. It is very tight in there major pain in the rear But yes my tailight does work.

Hey guys just woundering if there is a fuse in the axys for the heated visor cord? And wear its located?... my sled is a 15 switchback pro x... i hate chaseing wires just woundering if there is an easy answer on what and wear to look thanks guys.

Im happy with my ggb mountain can. Lite, small, good fit. Good choice If u arent scared of noise because its loud when wide open. I have noticed these axys sleds with electronic exhaust valves the first two stages arent alot louder then stock. I enjoy being able to cruise down the trail on a...

Yes wait till after break in. I personally think that is safest. one if the sled does have anything wrong with it or early warranty claims they wont fight u for aftermarket add ons. Two the computer does run with diffrent parameters in break in may cause some weird codes. three if u manage to...

It may change if u are talking an enclosed trailer, but for me i just have a open two place, U have to line it up straight to load for sure no diffrent then when i used ramps into truck (when i was single lol) but it works great as far as im conserned. U do have to watch as its very very...

I went to local hardware store and bought a 4'-8' sheet of puck board for i think 30$ and cut it up and screwed it down for carbides to ride on lasted two years so far...

im curios to how much more track you actually have in contact with the ground? in the pics it looks like you have only gained a couple inches at best,, did u measure the contact area with the 136 and 144 installed? just wondering because i would want the added ability in deeper snow. thanks.