• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Search results

  1. J

    Threebond for crankcase halves..

    Thanks Mike
  2. J

    Threebond for crankcase halves..

    Went to local dealer had a choice of 1184 or 1217f. The service manual calls out 1217h. Any thoughts which to use??
  3. J

    Water pump shaft end play

    I like this. Now how about diameter of bushing? Is there there an new case or bushing limit? I am about .001 to .0015 over new rear bushing.
  4. J

    Water pump shaft end play

    I am no gear expert that creates a new problem. The mess I found I don't want to be repeated. I have read other post some have said it was shimmed wrong please explain. All for sure is that my case bushing face is .015 deeper the original so now I have more play. I'm looking to find a shim to...
  5. J

    Water pump shaft end play

    I think the mechanical seal holds spring tension on crossshaft to crank. I guess if a tooth chips it will get pulled into and chewed up. I guess if it had a limit to be pulled forward maybe that scenerio wouldn't happen. Or just throw it in hope for the best.
  6. J

    Water pump shaft end play

    Thanks Mr. Sled . I have already looked through manual. I'm not sure if I'm asking for information that doesn't exist.
  7. J

    Water pump shaft end play

    Xcr 600 crank drive gear annialated for water pump. I'm at all new parts questioning end play on water pump shaft. Putting new shaft thrust washer new end bushing shaft moves .040 back and forth between bushings. (Technically called bearings). Is that too much? Bushing in case what would be...


Back
Top Bottom