axys a arm bushing slop?

[Burr600xc]

I did the procedure in the book of loosening the four bolts and pushing in on the mounts doesn't seem to help there seems to be a lot of movement of the spindle when you push up and down on the ski is this normal? unless I'm doing something wrong seems like a lot of slop for 600 miles . Anyone try the Indy Specialties brass bushings. Keith

 

[Brock]

If it's excessive clearance then it's not good

Ask your dealer for new ones and check with a vernier caliper vs old one?

 

[Burr600xc]

If it's excessive clearance then it's not good

Ask your dealer for new ones and check with a vernier caliper vs old one?

I know when I put a tape measure by the bolt on the spindle that holds ski on and push back and forth with the ski in the direction of from bumper to bumper I get about 3/16 movement. You can see the top A arm moving because of slop in bushing. I got some new bushing Ill have to take the old ones off to see if theres any difference. If not might have to go to aftermarket way .