Clutch alignment question

[Ottawaair]

'17 assault.

Got the alignment tool from ninja Plummer.

Laid it in there, hitting secondary,

Removed secondary and it has a .120 washer.

So after some messing around and checking, .080" behind secondary is what I need to got the tool to sit against front of secondary.
Providing zero float inwards.

I've read as much as I can about alignment, and Brock says minimum of .080", but later says minimum of .100" behind secondary.

Am I good with .080" behind and tool touching, then shim bolt to get .120" ??

 

[PRose]

I just took out my 0.12" washer and put a 0.06" washer in................when I had my secondary opened up I rotated it several times and could not feel the secondary hitting anything...........there is a few on hcs that have only the 0.06" washer in place and have not heard of those hitting the bulkhead..........

 

[Ottawaair]

Perfect. Thank you.

 

[Brock]

You can do 0.080 washer only behind secondary as I've said yes. I'd rather guys be safe so I've been saying 0.100" washer .