• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Hand Warmers

Muffin

Moderator
Staff member
Moderator
Messages
35
Age
50
Location
Athens, WI
Country
USA
Years Snowmobiling
30
Snowmobile
Yamaha Nytro
Yamaha Viper
Anybody else have problems with the stock hand warmers. I have a brand new Switchback and the left one gets nice and hot and the right gets lukewarm at best


Sent from my iPhone using Tapatalk
 
I started off with RH heater not working at all, dealer replaced then the LH would barely get hot while the replacement RH was smokin hawt.
Gave up on the dealer n replaced the LH with the alum bar version (which I suspect they'd also put on the RH side but dealer says no) on my own dime. All I can tell you, now both heaters are insanely hot hot hot.
 
This aluminum bar heater. Is this a Polaris or aftermarket part. I'm still learning Polaris as I've just come over from Yamaha.


Sent from my iPhone using Tapatalk
 
Install the cork under the grips and do spray foam inside of the handle bars. You can find the threads describing doing both either here or on hcs.
 
Early build / Ltd came with alum bars + higher output heaters. Even riding last two days at extreme temps, cycling bar heaters off n on low..........yea they get that hot.
 


Back
Top Bottom