• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Hill drag/ trail clutch setup

Dr.Notadoo

Dr.Notadoo

Well-Known Member
Messages
805
Age
54
Location
Richmondville
This is what I have found to work the best so far : front clutch 66 grm Cat weights with 2 grms added to base , stock spring, stock belt re shimmed( Cat weights are tucked more then Poo) 68 total. Rear clutch 48-44 full stock spring. 21-39 gear(1.86) stock chain and IQR tensioner . SSI pipe mod and pcvwith DTR hot map. Every else factory
 
UPDATE THE 3211111,IS THE BELT TO RUN ,WIDER THEN STOCK AND WAY MORE SURFACE AREA FOR CLUTCH CONTACT,BETTER GRAB, AND THIS BELT RUNS WAY COOLER CLUTCH SURFACES THEN STOCK BELT.HAVE TESTED IT MYSELF HANDS DOWN BETTER BELT..
 
You must log in or register to reply here.


Back
Top Bottom