• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Suspension set up

Pro S

New Member
Messages
8
Age
46
Location
Maine
Country
USA
Years Snowmobiling
20
Snowmobile
2017 Polaris switchback pro s le
Hi guys, just wondering what everyone has for a suspension set up to rail the corners. I have A 2017 Switchback Pro S LE. It seems to not corner real well and push when you try to turn. I weigh about 205, What's a good set up to run for Spring tension and clicks on the shocks. Thanks for the help.
 
Studded? I went with 6" shaper bars.
Yes studded with 2 in each row. Are your clickers on your shocks set low? Mine are in the center but thinking the
Spring tension is more of the issue?
 
Yes studded with 2 in each row. Are your clickers on your shocks set low? Mine are in the center but thinking the
Spring tension is more of the issue?
I have 6 Inch snow trackers
 
This is what I do to pro s to make them rail well

Hauling does too

front ski shocks. back off spring as far as you can till it becomes loose. Tighten an 1/8”-1/4” , set clickers to 4

Fts , go one inch, set clickers to 4

Rts, back off a little from stock if you can and set clicker to 4

Start off soft and go stiffer if you have too. Mark what you had for stock settings on everything and keep track of other settings

Start at that with you’re studs and 6” skags and try
 
Great thanks ill try this. Are the measurements on the shocks the exposed threads under the large nut or is it measured differently?
 
520F36EE-8F5B-4BA9-8023-C4E8F7C44253.jpeg
This shows fts shock. Measure from nut to body of shock as shown on all shocks and keep track of what you do

An 1/8” makes a huge difference
 
Perfect thanks again ill give this a go!
 


Back
Top Bottom