No I didn't get a hardness yet, Looking to get a new fuel pump, but I doubt if it will fix my problem since I'm cannot getting 14.6 vdc out of the Red wire off the VR even when I have the whole hardness not plugged into the RED wire. Anyone had a match I can borrow
I saw on the other post it should be around 4.3 to 4.5 amp DC anything over 5 amp DC will have problems, I didn't see anything on the Service manual how to test dc amp draw numbers so I have nothing to compare. I also ran the vin number if it did have a recall for the pump and the result negative.
The draw I have is 5.93 to 6 Amps DC to the fuel pump. Would this be too much to cuz voltage drop to the harness and no start when cap
is plugged in. No Cap is start (give and take).
First thank you for the information above
I was going to tell you the dc amp draw from the pump but my meter has a blown fuse. I soon I get a new fuse for the fluke meter I will let you know.
Your problem is the red wire to the relay coming from the VR, if no 14.6 vdcs from VR you will not have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.