Search results

You will not be disappointed with the bikeman pipe. I would pu the on trial performance of the bikeman pipe and the pipemod about the same, but they are both noticeably stronger than the stock pipe.

divyou have any pictures? Where exactly does the Dw plug in?

I have the docking station on its way. Where did you mount it and where did you pull power from ? Thanks

yes, when I called to order I could specify 3 or 4 wheels and shaft size.

I'm using a offset rear axle kit from avid products which you can get in either 20mm or 25mm and am running 4 arctic cat #3604-073 wheels.

I'm running 8" rear wheels off an arctic cat series

What a/f gauge is everyone running and do you like it. I'm getting ready to add one, I'm already running a bullydog so im looking towards the docking station.

Worked good for drag racing but was a bit too much for the trail.

Dalton 58/42 full prog. Helix. Not even 50miles. $75 shipped.

yes, if just changing wheels you put the offset facing forward. you can get fit 25mm bearings which fit avid 8" wheels or 20mm bearings. I actually order the 25mm by mistake I just turned the bearing surfaces down to 20mm.

yes all 8 inch wheels, im running 4, arctic cat #3604-073

I chose to get the axle kit for 20mm wheels and I am running black arctic cat wheels off an "m" sled in case I need to find a wheel on a trip.

check with these guys. http://www.avid-products.com/

Thanks for the help, Ive got the t-stat out at them moment , just reassemble with the seal?

Who is running their axys with out a thermostat? Of course you need to make sure it is warmed up good but have the operating tempatures decreased? Thanks

I tried the x spring on my s last year. it did help with the bottoming out but the ride quality suffered(I'm about #210). I have all my shocks at monster getting revalved at the moment andwill be switching back to the s spring.

on the 3/4" set screw there should be less than .1 of a gram difference between the two materials

The daltons worked good and were quick and easy to change , the reason went away from them is I could not get enough weight moved to wear I wanted but these were on 94gr arms so with a 70gr setup a few gram change will have more affect . With these you can also lock 2 smaller set screws against...

also to keep them balanced with each other depth mic or caliper for the edge of the entrance hole to each weight to verify they are screwed in to the same depth