Search results

Thumb warmer now functions and my high beam flicks off after idling for awhile and pops back on when revved up. Load relay was the ticket. Thanks again

Thanks, ordered another set but good to know

Just referred back to here and see your link shows CM1-R-12V. I ordered CM1A-R-12V as I was looking at another thread on HCS that gave that number Am I reordering???

Sorry I thought the initial chart you sent indicated at the top that resistance changes with temperature; thought that would determine heat generated from element. Will let ya know how what I find

Thank you again. Might just change them even if it works when i retry tomorrow. Load shed seems to flip over after a blip of throttle up over 2500 as High beam works so assumed relay was good. Had good power and good ground, never thought of temp as factor. Hope that’s it.. Appreciate the help

Ok, that’s how the warmer tests out…. Haven’t done any relays. I have power in the right places after the switch is toggled…. I’m going to throw the lever in the freezer and then try it. Might be a duh moment and it’s too warm to “activate”. Curious now about relays… tell me more.

Thank you very much for reply. Not sure I understand the low or high to chassis test, please explain.

Ok I know the thumb warmers suck but I had to replace my throttle lever as I broke it. Now thumb warmer does not work at all. I have power coming through switch properly to connection at thumb warmer harness after relay clicks in. Brown ground good. Where I’m puzzled is new thumb warmer...