Search results

TSS 04, jaws Pipe also

Thanks, I'll move some screws around, 48-44f 140-220 secondary

My new gates measures 1.48 across. That's quite a bit more than 1.42 for my newish (300mi) polaris. I could not fit the newest gates with my new tm weights. Anyone else notice these weights change clearance. Cg

Just installed a set of tm 60-70 in axys 800 and my engagement is now 4500. Those of you that use these weights is this the normal ? 10-68 was around 3800 before. They rip, but.... man this seems high. 120-310 60-70tm 3/8 tip, 1" heel Cg

This was a good show, more of a drag race than hill climb though. Couple good running assaults in stock.

anybody ever run this race in Turin, ny thinking about going up.... Cg

Doc, do you prefer the 65 base? Do you guys like these fully loaded or would you be better served buying the heavier base?

When you say 68.3g, are you using 8.3g set screw weight or are you considering the 60g base weight 65 and using 3.3g worth of screws? Everyone is running these around 68g it seems, which puts this weight around 73g polaris. Is the 65 base the better choice? I just bought the 60-70 and I hope...

Thank you, looking forward to hearing how they perform Cg

Pros800... the current gold stars are a 10 series now?? Cg

I have not seen any news since last season about the new profile. Will the new design be released ? Cg

just looking at the titan and that wide front, does anybody else think this may be the chassis to hold a future 4 stroke power plant??? Maybe I'm crazy Cg

Just had a 17' apart last night 58-44.36 came out. Same weight/ spring you've listed. (17' snocheck cobra track) Cg

Follow up- Found a single bare wire going into this converter, taped it and haven't seen the engine light again yet. Pwm to analog ? Not sure what this does, coincidence? Hopefully it was my problem Cg

thanks!, I did grease those connections. I'll check the 8pin tomorrow morning, I'm wondering what the fmi 5 correlates with? (3,4,10) are in owners manual under 520335 This is the first chance I've had the sled swamped and throughly soaked, so possibly something saturated that didn't see this...

Pennsylvania just got our first real snow in over two years. Fresh powder, drifting, snow over the hood, etc. Anyhow I have this engine light flashing today. What is going on here?

Do indy dans weights have a bushing in them? On his website it looked like no, but wasn't sure what stage of production the picture was taken. Cg

Where are the magnets coming from? Will Ssi, bikeman sell them alone? Cg

Have you tested these weights yet?? I'm anxious to hear how this works out. Afraid to try the Ssi, and the gold stars are too lazy of a profile? Cody g

Checking my buddies new 16' found alignment to be off. Single .120 spacer behind clutch,(factory), but will not clear 51607 tool with any more than a .020 spacer. Where to look? What to check?? Engine mount? Cody g