• We have updated the site to the latest version. You will be required to log in to make sure your account is active. There are quite a few new functions so it will take a little time to get use to it. Please post if you see or have any issues.

Cutler tm

cody geyer

cody geyer

Member
Messages
32
Age
38
Location
Loganton pa
Country
USA
Years Snowmobiling
22
Snowmobile
'16 rush pro s
Just installed a set of tm 60-70 in axys 800 and my engagement is now 4500. Those of you that use these weights is this the normal ? 10-68 was around 3800 before. They rip, but.... man this seems high.

120-310
60-70tm 3/8 tip, 1" heel

Cg
 
What is the belt to sheeve clearance? They may have the heals cut on these and you might have to shim the spider
 
cody geyer said:
Just installed a set of tm 60-70 in axys 800 and my engagement is now 4500. Those of you that use these weights is this the normal ? 10-68 was around 3800 before. They rip, but.... man this seems high.

120-310
60-70tm 3/8 tip, 1" heel

Cg
Click to expand...
Ditch the 120-310 and put in a 110-290. Load a 3/4 inch first, second a 3/8, and lastly a 1 inch screw. You're way too light unless you're still using the Team secondary.
 
You'll probable end up around 63-66gr. with those weights the have a very aggressive shift profile and will act 3-5gr. heavier than what they weigh
 
they work grat if you have good traction, they however will overshift easy in loose conditions and rpm will be a little low.
 
You must log in or register to reply here.


Back
Top Bottom