Cutler tm

cody geyer

cody geyer

Member
Messages
32
Age
39
Location
Loganton pa
Country
USA
Years Snowmobiling
22
Snowmobile
'16 rush pro s
Just installed a set of tm 60-70 in axys 800 and my engagement is now 4500. Those of you that use these weights is this the normal ? 10-68 was around 3800 before. They rip, but.... man this seems high.

120-310
60-70tm 3/8 tip, 1" heel

Cg
 
What is the belt to sheeve clearance? They may have the heals cut on these and you might have to shim the spider
 
cody geyer said:
Just installed a set of tm 60-70 in axys 800 and my engagement is now 4500. Those of you that use these weights is this the normal ? 10-68 was around 3800 before. They rip, but.... man this seems high.

120-310
60-70tm 3/8 tip, 1" heel

Cg
Click to expand...
Ditch the 120-310 and put in a 110-290. Load a 3/4 inch first, second a 3/8, and lastly a 1 inch screw. You're way too light unless you're still using the Team secondary.
 
You'll probable end up around 63-66gr. with those weights the have a very aggressive shift profile and will act 3-5gr. heavier than what they weigh
 
they work grat if you have good traction, they however will overshift easy in loose conditions and rpm will be a little low.
 
You must log in or register to reply here.


Back
Top Bottom